© Brüel & Kjaer Vibro ● S1079330.002 / V04 ● █ Page 127 of 188
Technical alterations reserved!
Brüel & Kjaer Vibro │ Instruction
VC-8000 MPS
Content
EN
18 Configuring - Analog Outputs Tab
Use the settings on the Analog Output tab to specify which
measurements (from that module) will be sent to the 4-20
mA connector on the UMM (or TMM).
Any measurement (Gap, or 1X) can be assigned as the
output to the analog output channel. The Direct
measurement is set as the output by default.
17-1) Analog Output tab
To Next Page
Loading...