Page 164 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
Action Screen Capture
Confirm that the channel is bypassed.
Select Close to return to the main screen.
Slot 3 Channel 3 is now in bypass.
Note: Relay channel 2 is no longer in alarm
because the channel driving the alarm has
been bypassed.
Note: Modbus and Analog outputs for slot 3
Channel 3 will go to their clamp values.
To re-enable the channel, select Disable
Bypass.
To Next Page
Loading...