Page 166 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
Action Screen Capture
Again, Notice that relay Slot 3 Channel 2 is still
active.
Also notice that the signal channels are still in
alarm.
Follow these same steps to bypass relay
channel 2 (if needed).
To re-enable the relay channel, select Disable
Bypass.
Bypass cannot be used to prevent relays from changing state during re-configuration, power
cycle, cards removed, firmware upgrades etc.
See section 6.9 Avoid False Trips.
To Next Page
Loading...