BRUEL & KJAER VIBROCONTROL 8000 - 1.3 Touch Screen Display Panel; Buffered Output BNC Connectors; 1.4 Rack Setup and Maintenance Software

To Next Page

To Previous Page

Technical alterations reserved!

Brüel & Kjaer Vibro │ Instruction

VC-8000 MPS

Content

1.3 Touch Screen Display Panel

The VC-8000 rack has an (optional) color touchscreen display module mounted on the rack or

remotely up to 10 ft. (3 m) away (like a cabinet door). The display module shows:

• All current data values

• All current data statuses

• Alarm set-points

• System Event List

• Alarm Event List

• Other hardware information

The display is mainly “view only”. Actions that

cannot be performed include:

• You cannot modify configuration settings

• You cannot bypass channels (alarms),

or relays.

Actions that can be performed include:

• Reset latched alarms and

acknowledgement

• Selecting signals for the 3 buffered output BNC connectors

1.3.1 Buffered Output BNC Connectors

There are three BNC connectors on the panel.

Select the BNC icon on the screen to choose the

channels for the BNC connectors. Any of the

channels in the rack can be selected

(see section 12.5.1)

1.4 Rack Setup and Maintenance

Software

Two software programs are used to configure and commission the VC-8000: VC-8000 Setup software

and VC-8000 Maintenance software. The VC-8000 Setup software provides:

• Configuration for all modules

The VC-8000 Maintenance software provides:

• Data display (verification) for all modules

• Other rack maintenance functions

Figure 1-7) TMM