Page 30 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
3.4 19” EIA Rack Mounting (rare)
This method is possible, but rare because most 19” EIA cabinets mount the equipment to the very
front of the cabinet (see below); this does not leave any room for wiring or wiring harnesses.
Recessed brackets can be ordered which push the rack several inches into the cabinet, but it is much
better to bulkhead mount the rack onto a subpanel in the cabinet rather than mounting to the rails.
Figure 3-4) Rack mounting
3.5 Weather Proof Enclosure Mounting
The small, compact VC-8000 rack easily mounts in weatherproof or explosion proof boxes. Please
see data sheet 1078951 for more information on weather proof housings (like IP54, splash protected).
Figure 3-5) VC-8000 8P Rack & Enclosure
Be sure to consider heat dissipation and ensure that temperatures will stay within specified limits. If possible,
keep the enclosure out of direct sunlight. Refer to the datasheets for power dissipation information. Provide
ventilation air if required.
14” (H) x 24” (L) x 18” (D) Enclosure
355 (H) x 609 (L) x 457 (D) mm
To Next Page
Loading...