Page 52 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
Figure 8-13) TMM process variable terminal block
8.2.4 Connecting Voltage Mode (< 1.5V) Transmitters
Voltage mode transmitters, with an output voltage range of less than 1.5 volts, can connect directly to
the TMM. Wire the positive output to the TMM channel B terminal and the negative output to the
TMM channel C terminal.
Overvoltage can damage the TMM. Generally, it is best to use a UMM for transmitter inputs.
To Next Page
Loading...