Page 80 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
11.6.1 Verify Your Remote MPS License
Remote connection requires a software license. To see if you
have the appropriate license:
• Connect to the rack with MPS Maintenance software.
• Select the Hardware Info tab and view the ‘supported
features’ column for Slot 2 (SAM).
• If ‘MPS Remote’ is green you have an active license.
11.6.2 Configure Remote Access in the SAM
Remote MPS Access uses the CMS port on the SAM. An IP
address must be configured and Remote MPS Access must
be specifically enabled.
• Connect to the rack with MPS Setup software.
• Select the Modules tab.
• Select row 2 (SAM) in the grid.
• Open the Properties pane.
• Enable Remote MPS Access, and set the
CMS IP Address.
• Send the configuration changes.
If Remote Connection is not licensed you will get a configuration error “MPS Remote access is
enabled, but is not supported by this module”.
11.6.3 Set User Account Passwords
A remote connection is not permitted until a password is set on the user account. Passwords are set
using the MPS Setup software. To set the password:
• Connect to the rack.
• Select File, Set Passwords
• (dialogue opens)
• Check Set Password.
• Enter the password.
• Click OK.
To change a password:
• Connect to the rack.
• Select File, Set Passwords.
• Enter the current password.
• (dialogue opens)
• Enter the new password.
• Click OK.
11-4) MPS Remote License is Active
11-5) Enable Remote MPS Access
11-6) Set Rack Passwords
To Next Page
Loading...