BRUEL & KJAER VIBROCONTROL 8000 - 12.1.4 Full Signal Channel View; 12.1.5 Relay Channel View

Page 86 of 188
█ © Brüel & Kjaer Vibro ● S1079330.002 / V04
Technical alterations reserved
EN
12.1.4 Full Signal Channel View
Select More (channel detail view) to see the Full Channel view.
Figure 12-2) Full Signal Channel View
12.1.5 Relay Channel View
Select any relay channel to see the relay channel view. Notice that all four relay channels are shown
on the screen, but only one channel is the “selected” channel.
1) Selected relay channel.
2) Bypass the selected relay channel
3) Selected relay channel status.
4) Logic block – Motor High Vib.
5) Relay – Motor High Vib
6) Logic block – Motor High High Vib.
7) Relay – Motor High High Vib
8) Relay – Spare (Ch 3)
9) Relay – Spare (Ch 4)
Figure 12-3) Relay Channel View
The logic and/or relay channel will turn red when active.
Enable Bypass is only available using the Maintenance software connected to the rack from a laptop.
Enable Bypass is not available from the local touchscreen panel.