BRUEL & KJAER VIBROPORT 80 - Page 112

Translation of the Original Operating Instructions
VP-80/VP-80 E
105
High-Pass e.g. 10 Hz
High-pass limit fre-
quency (range
depends on input
channel setting).
Low-Pass e.g. 1000 Hz
Low-pass limit fre-
quency (range
depends on input
channel setting).
Low-Pass FFT e.g. 1000 Hz
Depends on whether
SED or BCS has been
selected under Unit.
Y-axis
Linear; Logarith-
mic; dB
Scaling of Y-axis.
Input Range
Automatic Sca-
ling; Maximum;
Sensor Units
Depends on setting in
System Setup, only
appears if Sensor
Units has been selec-
ted. Automatic Scaling
should be set by
default.
dB Reference Any
Reference value for
location of dB range of
Y-axis. Depends on
setting in Y-axis.
dB Ref Units
m; 10
3
m; 10
6
m
Scaling of dB range of
Y-axis. Depends on
setting in Y-axis.
Detection
rms; p; pp; pc;
ppc
Signal detection.
Lines 100 to 25,600 Line resolution of FFT.
Parameter
Setting para-
meter
Explanation of para-
meter