BRUEL & KJAER VIBROPORT 80 - Tracking - Signal Processing Setup

Translation of the Original Operating Instructions
VP-80/VP-80 E
113
9.6.1 Tracking - signal processing setup
Tab. 13 Setup parameters for tracking before calculation
Parameter
Setting para-
meter
Explanation of para-
meter
Channels CH1; CH2; CH3
Channel used for cal-
culation.
Start
Speed(RPM)
e.g. 600 rpm
Definition of data
acquisition speed…
Stop
Speed(RPM)
e.g. 1.500 rpm
Definition of data
acquisition speed…
Spacing
e.g.
rpm
Type of delta or inter-
val of the X-axis.
Speed Inter-
val (RPM)
e.g. 10 Value of speed interval
Time Interval
(s)
e.g. 1 Value of time interval
Display Units e.g. g
Display unit after cal-
culation, which per-
forms an integration
during the calculation if
required.
LF Cutoff On; Off
Filter for filtering low-fre-
quency interference.
Detection rms; pc; ppc
Signal detection or
detection of overall.
Y-axis
Linear; Logarith-
mic
Scaling of Y-axis
Show Overall On; Off
In addition to the dis-
played orders, a total
vibration overall can
be displayed.
Num Traces 1; 2; 3 (4)
Number of orders to be
calculated.
Order #1
(#2,#3,#4)
e.g. 4
Orders which are cal-
culated.