Translation of the Original Operating Instructions
VP-80/VP-80 E
11
C
i
= 300 nF
L
i
= 0
Marking
II 3G Ex ic IIC T4 Gc Ta= -10°C to +50°C
CSA approval only for VP-80
CSA Class I, Div 2 Groups A, B, C & D, Temperature Code
T4A@Ta=50C
3.2 General information
In the following you will find safety advice in relation to the use
of the VIBROPORT 80 E in potentially explosive atmosphe-
res.
This information is based on Directive ATEX 94/9/EC.
Note!
In addition to the general installation regulations for electrical
systems, when installing electrical systems in potentially
explosive atmospheres IEC 60079-14 and the relevant natio-
nal requirements on the installation of explosion-proof sys-
tems must be observed.
To Next Page
Loading...
