BRUEL & KJAER VIBROPORT 80 - Power Supply Module

Translation of the Original Operating Instructions
VP-80/VP-80 E
35
6.1.3 Power supply module
To charge the battery fitted in the VIBROPORT 80 use the
AC-7001 power supply module in conjunction with the do-
cking station, or an AC-1389 splitter cable (special accessory
provided in the scope of supply).
Adapter
The power supply module is equipped with different adapters,
which allow the VP-80 to also be connected to other power
grids which do not use the connector (type F / CEE 7/4).
To change the adapter, proceed as follows:
WARNING!
Explosive atmosphere!
Do not use the power supply module in potentially explosive
atmospheres.
This can cause explosions, resulting in damage to property
and injuries.
• Never use the power supply module in potentially explo-
sive atmospheres.
i
Note!
The enclosed operating instructions for the AC-7001 power
supply module must be read, understood and complied with.
Pay special attention to the operating temperature of the
power supply module.
i
Note!
Use the power supply module to charge the battery. Do not
cover the power supply module.
i
Note!
Before using the VIBROPORT 80 for the first time, the fitted
battery must be charged for at least 24 hours, so that it can
reach its full capacity.