BRUEL & KJAER VIBROPORT 80 - 6.2.3 Report & EXaminer Software

Translation of the Original Operating Instructions
VP-80/VP-80 E
40
6.1.4.3 Changing the battery
Change the battery of the VP-80 as follows:
 Set up the VP-80.
 Unscrew the four screws of the battery cover.
 Remove the battery cover.
 Disconnect the battery from the VP-80.
 Insert the new battery.
 Put on the battery cover.
 Screw the four screws into the battery cover.
WARNING!
Explosive atmosphere!
Do not change the battery and the power supply module of
the device in potentially explosive atmospheres.
This can cause explosions, resulting in damage to property
and injuries.
• Therefore only change the battery outside potentially
explosive atmospheres.
• Only use the power supply module outside potentially
explosive atmospheres.
i
Note!
The fitted battery has a long service life and only needs to be
changed in the event of a defect. A defect is present if the
battery cannot be charged sufficiently.
i
Note!
The battery may only be changed when the device is swit-
ched off. Otherwise the device may be damaged.
i
Note!
The internal clock and the system control are maintained for
10 minutes when changing the battery. They must be reset at
the end of this time.