BRUEL & KJAER VIBROPORT 80 - Folding out the Bracket

Translation of the Original Operating Instructions
VP-80/VP-80 E
42
USB connection for connecting to a computer
Here you can connect the VIBROPORT 80 in the docking sta-
tion to a PC via USB connection. Data can then be exchanged
between the VIBROPORT 80 and the PC and / or further pro-
cessed and analyzed on the PC using the Report & EXaminer
software.
USB connection for connecting a further USB device
This connection is currently not active and therefore cannot
be used (intended for future developments).
6.1.6 Folding out the bracket
If you wish to set up and operate the VP-80 on a work surface,
it can be positioned at an ergonomically favorable angle using
a bracket on the back.
Fig. 7 Folding out the bracket
 Release the bracket from the holder by pressing the clips
down at both holding points and pulling the bracket for-
ward.
 Fold out the bracket.
 Set up the VP-80.