BRUEL & KJAER VIBROPORT 80 - Softkeys; General

Translation of the Original Operating Instructions
VP-80/VP-80 E
65
7.6 Softkeys
7.6.1 General
• Change softkeys
• These softkeys change automatically when activated
with the function key.
For example: HZ/rpm or EXPAND/REDUCE.
• Gray softkeys
• When these softkeys are activated with the function
key, the function is activated. The softkey appears gray
until it is executed again and the function is thus deacti-
vated again.
For example: AVERAGE or RECORD.
• Dynamic softkeys
• If you change to another level, for example, or navigate
to specific measuring tasks, Help or New Measurement,
certain softkeys are automatically faded in or out. I.e.
the functionality of the softkeys is context-sensitive.
For example: SYSTEM SETUP or START.
i
Note!
Softkeys are called up via the respective function keys (F1 to
F6).
i
Note!
The softkeys are dynamic and adapt according to the given
mask and situation.
i
Note!
The operator interface of the VIBROPORT 80 has four levels
in which you can navigate with the softkeys (see following
figure).