Translation of the Original Operating Instructions
VP-80/VP-80 E
69
> INFO
Pressing the displayed INFO softkey again using function key
F2 gives you access to further information on the VIBRO-
PORT 80. However, this is not relevant for standard use.
7.6.4 Level 2 / Modules
When a module is opened / started, the following standard
softkeys are available:
HELP
The general functions of the mask / module and its options
are described here.
• Last measurement
• Repeat the last measurement carried out in this module
with the same setup. In this case you can START the
measurement directly or call up the SETUP again.
• New measurement
• New measurement with new setup.
• Report
• Load saved setup or saved data of a measurement.
• Predefined measurements
• All other symbols / icons represent predefined measure-
ments. These can be started directly or started with
recalling the setup behind the predefined measurement.
> BACK
This softkey takes you back to the main mask of the module.
Note!
The softkeys on the second level, i.e. the main masks of the
modules, always have the same structure (HELP, SETUP,
REPORT, START and EXIT).
To Next Page
Loading...
