BRUEL & KJAER VIBROPORT 80 - Level 3; Measurement Setup and Report Mask

Translation of the Original Operating Instructions
VP-80/VP-80 E
71
7.6.5 Level 3 / Measurement setup and report mask
Measurements that are started with the fire key open a setup
input mask before the measurement, where the settings for
the measurement are defined.
Measurement setup
HELP
Activating this softkey displays general information on the
measurement setup (cursor keys, fire key, softkeys).
The measurement setup parameters are also described in de-
tail here.
DEFAULT
Activating this softkey resets the settings of the measurement
setup to the default values.
EXPAND/REDUCE
The EXPAND softkey fades in all setting options for the setup.
The REDUCE softkey displays fewer setting options.
STORE
The STORE softkey saves the currently set setup in the Re-
port mask so that it can be reused later.
START
The measurement is started with this softkey.
EXIT
The setup is rejected with this softkey.
The settings and measurements can be used again with the
OPEN softkey.
i
Note!
All softkeys are only available here, if a measuring file or
setup file has been selected in the report mask!