Translation of the Original Operating Instructions
VP-80/VP-80 E
77
Using the cursor keys
During the measurement and when it is finished, information
about individual spectral lines/amplitudes can be selected
with a cursor.
Activate the cursor function by pressing the cursor key
(right, left) once.
Select the desired position by pressing the respective cur-
sor key (right, left).
The measuring values for the selected position are dis-
played numerically. Information e.g. on the individual spec-
tral lines (amplitude and frequency) is also displayed.
Miscellaneous keys
• Harmonic Cursor
• The Harmonic Cursor is activated with key 4. Activating
this softkey again deactivates the cursor / fades it out.
• Peak Find Cursor
• The Peak Find Cursor is activated with key 7. This cur-
sor jumps to the max. 5 highest peaks in a spectrum.
Activating this softkey again and again, cycles through
the highest peaks.
• Change signal
• The key combinations 0+Shift up or 0+Shift down
change the cursor from one signal to the next, if more
than one signal curve is present in a diagram.
Note!
The current X/Y position of the cursor is displayed in the top
left corner (near the header line). This means that you always
know where the cursor is located.
To Next Page
Loading...
