Translation of the Original Operating Instructions
VP-80/VP-80 E
79
MODULES
This softkey calls up the Module Manager. This allows you to
install, deinstall or hide modules.
• INSTALL
• This function may only be executed by our service per-
sonnel. Please do not press this key!
• DEINSTALL
• This softkey allows you to deinstall purchased modules
which you no longer require. Please note the security
advice above. Alternatively, you can hide the modules.
• HIDE/DISPLAY
• Hiding modules is designed to optimize the Main Mask.
The modules can be faded in again at any time.
• Hidden modules are identified by square brackets in this
mask.
•SELECT
• You can select and deselect individual modules with
this softkey. Selected modules are indicated by the acti-
vated checkbox on the left.
• Selected modules can be installed, deinstalled, dis-
played and hidden.
OK
Executing the OK softkey saves the settings made in the Sys-
tem Setup and takes you back to the Main Mask.
Note!
This can irrevocably restrict the functionality of the VIBRO-
PORT 80. Special attention should be paid to deinstalling.
Deinstalling should only be carried out if you are certain that a
module is no longer required. Deinstalling modules will
relieve the processor of the VIBROPORT 80 and thus incre-
ase processing speed.
To Next Page
Loading...
