BRUEL & KJAER VIBROPORT 80 - Start of Example Measurement; Perform New Measurement

Translation of the Original Operating Instructions
VP-80/VP-80 E
89
You will find setups (identified by a sheet as icon) and measu-
rements (identified by a sheet with a tick as icon) listed here.
8.1 Start of example measurement
The Overalls module is used for the example measurement
here. In principle all module masks / overviews are very simi-
lar and are operated according to the same logic.
The procedures and settings described below can therefore
be transferred to the other modules.
Proceed as follows:
 Start the VIBROPORT 80 with the On/Off key.
 The device starts.
 The main mask appears.
 Select the Overalls module with the cursor keys.
 Press the fire key.
 The Overalls mask opens.
8.2 Perform new measurement
You can perform a new measurement here. Before starting a
setup mask will be displayed, in which you can set up the new
measurement.
 Select New measurement with the cursor keys.
 Press the fire key.
 Edit the Setup if necessary.
 Press the START softkey.
 Perform the new measurement.
 End the new measurement with the EXIT softkey.
i
Note!
If you have not yet correctly connected the necessary sen-
sors to the VIBROPORT 80, do this now.
i
Note!
The STOP and STORE softkeys allow you to save the cur-
rent measurement in theReport and reuse it.