BRUEL & KJAER VIBROPORT 80 - Perform Predefined Measurement

Translation of the Original Operating Instructions
VP-80/VP-80 E
90
8.3 Perform predefined measurement
Predefined measurements are specifically designed for fre-
quently occurring measuring tasks. Therefore these measu-
ring tasks do not have to be specially created and saved.
Predefined measuring tasks can be started directly (START
softkey) or configured (fire key) or SETUP softkey before star-
ting the measurement.
The settings of the setup can be individually configured, but
will always be reset to the respective default setting when the
setup is next used.
 Select the predefined measurement with the cursor keys.
 Press the START softkey (directly to measurement) or the
fire key or the SETUP softkey.
 Edit the Setup if necessary.
 Press the START softkey.
 Perform the predefined measurement.
End the predefined measurement with the EXIT softkey.
i
Note!
The STOP and STORE softkeys allow you to save the cur-
rent measurement as a report and reuse it.