BRUEL & KJAER VIBROPORT 80 - 9 Setup Parameters for the Measuring Modules; 9.2.1 Vibration Acceleration and Vibration Displacement Measurements

Translation of the Original Operating Instructions
VP-80/VP-80 E
91
8.4 Perform last measurement and check setup
If you wish to call up and check the settings of the Last mea-
surement (or a predefined measurement) before you perform
this measurement, proceed as follows:
 Press the fire key (or the SETUP softkey).
 The Overalls setup mask opens.
Fig. 17 Setup of the last measurement
 Check the connected sensors in the Setup of the Overalls.
 Edit the Setup settings if necessary.
 Save them with the STORE softkey, if you wish to reuse the
edited settings at a later point in time.
 Start the measurement with the START softkey or the fire
key.
 The measurement starts.
i
Note!
The EXPAND softkey displays all setting options for the
setup. The REDUCE softkey only displays the basic setting
options, which are adequate for most applications.