Translation of the Original Operating Instructions
VP-80/VP-80 E
92
8.5 Directly start last measurement
If you wish to repeat the Last measurement carried out, pro-
ceed as follows:
Press the START softkey.
The Overalls data mask opens and the measurement starts
directly (indicated by softkey F5 which displays STOP =
Measurement running).
Fig. 18 Measurement of overalls
In this example a single-channel measurement, with overall
only in path A, is displayed in both a table and as a bar chart -
the main value selected in the setup was [mm/s] rms (see pre-
vious page).
Note!
The softkeys provide different functions during the measure-
ment.
To Next Page
Loading...
