Bruker Anton Paar - Figure 10.1: Import Template from File

Appendix / Service Details
DOC-M88-EXX268_V1_12.2016 101
1. Switch on the Anton Paar controller and wait until the booting process is finished.
Follow the instructions on the controller.
2. Launch the DIFFRAC.MEASUREMENT CENTER [4] program.
3. Switch to the CONFIGURATION plugin.
4. Open Device| Goniometer| Center and insert a template by pressing the right
mouse button and selecting Import Template (figure below).
Figure10.1: Import template from file
5. Choose Stage_PAAR_HTK1200_Motorized.bfscn in C:\ProgramData\Bruker AXS
\Instrument Configurations\A25\D8_Advance\Stages: