Bruker Anton Paar - Mounting the Temperature Controller into the D8 Enclosure

Mounting the Temperature Controller into the D8 Enclosure
DOC-M88-EXX268_V1_12.2016 47
5 Mounting the Temperature
Controller into the D8 Enclosure
Four height units are required to mount the Anton Paar controller into the rack. Depending
on other components, the fitting position varies.
The controllers are coming in table top housings and can be mounted into the D8 enclo-
sure. Use the mounting set to fix the controller in the 19” rack.
Steps to be taken:
1. Loosen the screws on both sides of the controller base and remove the covers.
Figure5.1: Removing the covers for rack mounting
2. Fix the guide bars on both sides of the controller.
Figure5.2: Fixing the guide bars on both sides of the Paar controller