Bruker Anton Paar - Installation and Operation of the HTK-Series, TTK 600, XRK 900, and HPC 900 Chambers; Introduction

Installation and Operation of the HTK-Series, TTK 600, XRK 900, and HPC 900 Chambers
DOC-M88-EXX268_V1_12.2016 49
6 Installation and Operation of the
HTK-Series, TTK 600, XRK 900,
and HPC 900 Chambers
6.1 Introduction
This chapter contains all relevant user information for installing and operating a range of
Anton Paar temperature chambers that are all mounted in the goniometer center and have
similar modes of operation.
Chambers that are included are the following:
• HTK 1200N: High temperature chamber using oven heating to generate temperatures
up to 1200°C in various atmospheres.
• HTK16N: High temperature chamber using a strip heater to reach temperatures up to
1600°C in various atmospheres.
• HTK 2000N: High temperature chamber using a strip heater to reach temperatures up
to 2300°C in vacuum or up to 1600°C in various atmospheres.
• TTK 600: Low- and high temperature chamber capable of reaching temperatures
between -190°C and 600°C in vacuum or room temperature and 450°C in various
atmospheres.
• XRK 900: High temperature reactor chamber for in-situ studies using a furnace heater
to reach temperatures between room temperature and 900°C under gas pressures up
to 10bar.
• HPC 900: High temperature reactor chamber for in-situ studies using a furnace heater
to reach temperatures between room temperature and 900°C under gas pressures up
to 100bar.