Bruker Anton Paar - Configuring the Chamber in DIFFRAC.MEASUREMENT CENTER

Installation and Operation of the DCS 350 and DHS 1100 Chambers
76 DOC-M88-EXX268_V1_12.2016
Figure8.3: Front view of a TCU series controller with built-in Eurotherm 2604 controller
Figure8.4: Front view of a CCU100 Controller
Mounting of the temperature controller into the diffractometer cabinet is described in chap-
ter Mounting the Temperature Controller into the D8 Enclosure [}47]. The steps for the
software integration of both chambers are given in chapter DCS 350 and DHS 1100
[}126] of the Appendix / Service Details [}99].
8.4 Configuring the Chamber in DIFFRAC.MEASUREMENT
CENTER
Normally, Anton Paar stages come preinstalled with a new system or will be installed by a
Bruker technician upon purchase. They should therefore be ready to use. If this is not the
case, or for some reason the chamber needs to be reinstalled in DIFFRAC.MEASURE-
MENT CENTER, we refer to chapter DCS 350 and DHS 1100 [}126] of the Appendix /
Service Details [}99].