Bruker Anton Paar - Optimizing Two Theta; Figure 8.15: Twotheta Scan to Align the Bragg Angle

Installation and Operation of the DCS 350 and DHS 1100 Chambers
88 DOC-M88-EXX268_V1_12.2016
8.6.2.2 Optimizing Two Theta
u When using a 1D detector, use a single strip. When using a 0D detector, use a 0.1mm
detector slit.
1. With Theta positioned at the peak position measured previously, scan Two Theta.
2. Move Two Theta to the peak position.
Figure8.15: TwoTheta scan to align the Bragg angle