Bruker Anton Paar - Creating a Temperature Dependent Measurement Using the WIZARD; Figure 8.17: Transmit Drive Positions from COMMANDER to WIZARD; Figure 8.18: Create an HR-XRD Measurement for Your Sample

Installation and Operation of the DCS 350 and DHS 1100 Chambers
90 DOC-M88-EXX268_V1_12.2016
8.6.3 Creating a Temperature Dependent Measurement Using the WIZARD
u In COMMANDER, make sure that all drives are at the aligned position for the desired
reflection.
1. Click COMMANDER | Transmit Drive Positions.
Figure8.17: Transmit drive positions from COMMANDER to WIZARD
2. Create an HR-XRD measurement for your sample.
Figure8.18: Create an HR-XRD measurement for your sample
3. Generate a sample definition for your sample as you would do for a normal HR-XRD
measurement.