Bruker Anton Paar - Figure 8.19: Selecting the Aligned Sample Reflection; Figure 8.20: Import the Centered Values from COMMANDER

Installation and Operation of the DCS 350 and DHS 1100 Chambers
DOC-M88-EXX268_V1_12.2016 91
4. In the Alignment section, choose the aligned Bragg reflection. The positions to be
aligned must be set to Required.
Figure8.19: Selecting the aligned sample reflection
5. Import the aligned motor positions from COMMANDER by pressing the Import from
COMMANDER button.
Figure8.20: Import the centered values from COMMANDER
6. Define a measurement in the Method section.
7. In the Sequences section, define a temperature sequence by pressing the button Add
new sequence.