Bruker AQS - Configuration and Status Register

 %
  
  
 %

 &"  #"! !$! #

Address
Byte Format
3210
Read/WriteDestination
1F007FEx ,+/&  222!
1F007FFx $ -  222!
4. 2. 10. Configuration and Status Register
Notes
 There are 4 configuration register and 1 status register. Each of them is 8
bit wide.
 Each configuration register provides two hexadecimal digits indicating
the version of two individual onboard subsystems as follows:
 0$-.',+
  2 ,+ 
-,"$..,- 0$-.',+   2
$ ) '*$ ),"( 0$-.',+   2
$3!, -# ,+/-,))$- 0$-.',+   2
 +/$-% "$ 0$-.',+   2
/&$-+$/ 0$-.',+   2 ,+ 
  2 %,-  1'/&
,+)3
  2 %,-  1'/&  +#

 ,+/-,))$- 0$-.',+   2
A subsystem is not available if the respective digit equals to zero. All configuration
register outputs are provided in their negated form
The STATUS register accommodates the temperature and VME bus time out status bits, 4 LED
bits and 3 control bits of the ”CIS” channel (component identification system).
Read access to the STATUS register provides the occurrence of TMP_INT (temperature
interrupt) on bit 1 and the occurrence of vme bus time out on bit 0 since last read. Both
are low active and cleared in sequence of a read. Bit 3 of the status reflects the state of
SDA, this is the serial data line of the VME–Bus.