28
Cleaning procedure of the inner hydraulic circuit
Before making your first coffee and every time the devise is inactive for a long period,
follow the procedure described below to effectively clean the inner hydraulic circuit.
1. Make sure the appliance is not connected to the power supply.
2. Fill the water tank (4) with cold water without exceeding max level indicator and make
sure the water tank is installed properly and there is not any leakage.
3. Insert the adapter in the appliance without any capsule and
press down the lever (1).
4. Connect the appliance to the power supply.
5. Press On/Off button to turn on the appliance. The indication
lights of the functions buttons (On/Off - Short Espresso -
Lungo)(2) will start to blink for about 45 sec indicating the
appliance is heating up. After heating up the indication lights
will turn solid.
6. Place a cup on the drip grid (6) and press the Lungo coffee
button.
7. When the procedure is complete press On/Off to turn off the
appliance and disconnect from the power supply.
To Next Page
Loading...