34
Coffee brewing with ground coffee
1. Make sure the appliance is not connected to the power supply.
2. Fill the water tank (4) with cold water without exceeding max level indicator and
make sure the water tank is installed properly.
3. Lift the lever (1) to release the adapter (5).
4. Pull out the adapter (5) to remove it from the
appliance.
5. Open the adapter’s lid (5).
6. With the measuring spoon add ground coffee in the
stainless steel filter inside the adapter (5) and with
the flat surface of the measuring spoon press slightly
to even the ground coffee. Remove any coffee
remainings on the edge of the filter.
7. Close the adapter’s lid (5).
8. Insert the adapter (5) in the adapter input on the
appliance.
9. Press down the lever (1) to secure the adapter (5).
10. Connect the appliance to the power supply.
11. Press On/Off button to turn on the appliance. The
indication lights of the functions buttons (On/Off -
Short Espresso - Lungo)(2) will start to blink for about
45 sec indicating the appliance is heating up. After
heating up the indication lights will turn solid.
To Next Page
Loading...