13
USING YOUR LEGACY LINE Wi--Fi THERMO-
STAT
The bright, easy--to--read screen on your Legacy Line Wi--Fi Thermostat
makes it simple to review and adjust the settings any time you want.
Adjusting the Temperature
You can easily adjust the temperature without changing the Legacy Line
Wi--Fi Thermostat’s schedule by pressing the arrow keys when the Home
screen is displayed.
d Press Y to increase the temperature set point by 1° F(0.5° C).
d Press B to decrease the temperature set point by 1° F(0.5° C).
d If the Legacy Line Wi--Fi Thermostat is set to Auto mode, press
A to select the Cool setting.
d If the Legacy Line Wi--Fi Thermostat is set to Auto mode, press
" to select the Heat setting.
Once you’ve adjusted the temperature, the screen indicates that you are
currently holding the set temperature rather than running a program.
The Legacy Line Wi--Fi Thermostat will hold the new temperature for
the duration you specified in the Hold Action option during the initial
setup (see Hold Action on Pg. 20) or until you press OK.
If you are using Auto mode, note that there is a minimum difference
allowed between heat and cool set temperatures. The system will prevent
you from setting the temperatures within these limits. See the Legacy
Line Wi--Fi Thermostat Installation Manual for information about
configuring the minimum temperature difference settings.
System Mode
To change system mode:
From the Home screen, press MENU.
Select System Mode.
Select your temperature mode: Heat, Cool, Auto or Off.
This menu sets your system to use heat, cool, or auto mode:
To Next Page
Loading...
Need help?
General
