Need help?Do you have a question about the BSS Audio FDS366T OMNIDRIVE and is the answer not in the manual?
General| Type | Digital Signal Processor |
|---|---|
| Output Channels | 6 |
| A/D Conversion | 24-bit |
| D/A Conversion | 24-bit |
| Sample Rate | 48 kHz |
| THD+N | < 0.01% |
| Input Connectors | XLR |
| Output Connectors | XLR |
| Power Supply | 100-240V AC, 50-60 Hz |
| Frequency Response | 20Hz - 20kHz, +/-0.5dB |
| Dynamic Range | >110 dB |
| Limiter | Yes |
| EQ | Parametric Equalizer |
Details the product's functionalities, typical uses, and technical specifications.
Guides on connecting power, audio, and understanding basic system setup.
Provides essential steps for initial operation and quick how-to guides.
Covers storing, recalling, locking, and managing programs.
Detailed explanation of input channel parameters like Gain, Delay, EQ Bypass, and DEQ.
Configuration of the Dynamic Equaliser compressor settings.
Output channel settings including Name, Source, and Crossover.
Information on MIDI, RS232, RS485, and how to resolve common issues.
Defines the Dynamic Equalisation feature and its purpose.
Explains how DEQ compresses specific frequency bands.
Details the available configuration modes like Mono, Stereo, and LHLHLH.
How to set crossover frequencies and band delays.
How to apply EQ to channels and adjust parameters.
Setting up limiter parameters for speaker protection.
Method for aligning speaker drivers using delay settings.
Explains the function and use of program locks.
Settings for input/output routing and signal summing.
Parameters for crossover, phase, alignment, delay, and temperature.
Detailed explanation of Lock Out, Owner Lock, and OEM Lock security features.
Utility options for managing programs like storing, backup, and deletion.
Explains the process and requirements for using the Alignment Assistant.
Guidance on proper microphone setup for measurements.
How to choose which bands to include in the measurement.
Setting the appropriate signal level for accurate measurements.
How to enable lock out mode to prevent editing.
How to hide parameters and protect them with a password.
Step-by-step instructions for enabling and configuring owner locks.
Process for saving programs with owner lock applied.
How to apply additional locks to specific parameters.
Explains the highest level of security for OEM lock.
Step-by-step instructions for enabling and configuring OEM locks.
Process for saving programs with OEM lock applied.
How to apply additional locks to parameters using OEM mode.
How to dump program settings via MIDI for backup or transfer.
How to enable the Dynamic Equaliser and its operation modes.
Configuring the threshold level and ratio for compression.
Adjusting the attack and release times for dynamic EQ.
Configuring the low-pass filter shape and frequency.
Configuring the high-pass filter shape and frequency.
Turning the limiter on/off and setting the brickwall overshoot level.
Configuring the limiter's threshold, attack, and release times.
Detailed explanation of DEQ threshold and ratio settings.
Adjusting attack and release times for dynamic equalization.
Solutions for unit not powering up or having no audio output.
Resolving problems with saving programs and unclear LCD graphics.
To Next Page
