How to recycle your equipment
The symbol shown here and on the product
means that the product is classed as electrical
or electronic equipment, so DO NOT put it in
your normal rubbish bin.
It’s all part of the Waste Electrical and Electronic
Equipment (WEEE) Directive to recycle products in
the best way – to be kinder to the planet, get rid of
dangerous things more safely and bury less rubbish
in the ground.
You should contact your retailer or supplier for advice
on how to dispose of this product in an environmentally
friendly way.
Warning
You won’t be able to call 999 from this phone if there’s a
power cut, so make sure you’ve got another way to call
for help in an emergency.
R&TTE Directive & Declaration of Conformity
This product is intended for use within the UK for
connection to the public telephone network and
compatible switchboards.
This equipment complies with the essential
requirements for the Radio Equipment and
Telecommunications Terminal Equipment Directive
(1999/5/EC).
For a copy of the Declaration of Conformity
please refer to bt.com/producthelp
BT2700
Digital Cordless Phone with Answer Machine
General information
For information on safety instructions,
cleaning, technical information or connecting
to a switchboard, please refer to the ‘General
information’ section in the full user guide at
bt.com/producthelp
Guarantee
Your BT2700 is guaranteed for a period of 12 months
from the date of purchase.
Subject to the terms listed below, the guarantee
will provide for the repair of, or at BT’s or its agent’s
discretion the option to replace the BT2700, or any
component thereof, (other than batteries), which is
identied as faulty or below standard, or as a result of
inferior workmanship or materials. Products over 28
days old from the date of purchase may be replaced with
a refurbished or repaired product.
The conditions of this guarantee are:
• The guarantee shall only apply to defects that occur
within the 12 month guarantee period.
• Proof of purchase is required.
• The equipment is returned to BT or its agent as
instructed.
This guarantee does not cover any faults or defects
caused by accidents, misuse, fair wear and tear,
neglect, tampering with the equipment, or any
attempt at adjustment or repair other than through
approved agents.
This guarantee does not aect your statutory rights.
To nd out what to do, if your phone is in or outside
of the 12 month guarantee, please look in the full user
guide at bt.com/producthelp
What’s in the box
Mains power adaptor
(item code 066270)
Telephone line cord
(pre-installed)
2x AAA NiMH 550mAh
rechargeable batteries
(already in handset)
1 Plug in 2 Charge
1 Activate the batteries by pulling the plastic tab away from
the bottom of the handset.
2 The handset will check for a link with the base station.
Once found, follow the prompt to set the date and time.
3 Place the handset on the base to charge the batteries for 16 hours.
Important: you should charge the batteries for 16 hours before
using the handset for the rst time.
16 hrs
Your BT2700 is now ready to use.
Please
turn
over
Please
turn
over
© British Telecommunications plc 2016.
Registered Oce: 81 Newgate Street, London EC1A 7AJ. Registered in England No. 1800000
Designed and produced by The Art & Design Partnership (ADP). Printed in China / Issue 2 / ADP09-16
Important: Only use the mains power adaptors, cables and rechargeable batteries
supplied in this box, or this product may not work. Any replacement rechargeable
batteries must be the same type. BT accepts no responsibility for damage caused to
your phone by using any other type of batteries.
Mains power adaptor
(item code 066270)
2x AAA NiMH 550mAh rechargeable
batteries (already in handset)
For each additional handset (if you’ve bought a multipack)
Set up your additional handsets (if you’ve bought a multipack)
1 For each additional handset and charger: plug the mains power adaptor into the
socket on the underside of the charger, secure the cable behind the retaining clip
and plug the other end into the wall power socket and switch on.
2 Activate the batteries as shown above. Then place the handset on the charger
to charge for 16 hours.
Troubleshooting
Most problems can be xed with a few simple checks.
Problem Solution
No dial tone Only use the cables supplied.
Make sure the telephone line cord is plugged in correctly.
Handset not charging Make sure the handset is turned on before placing on the
base or charger to charge.
Phone ringer does not ring The ringer volume may be set to Ringer o. Adjust the
handset Ring volume. Check that Block mode or Do Not
Disturb is not switched on.
Using broadband on the
same phone line?
To avoid problems with your broadband or noise on your
phone line, you might need to plug your telephone line
cord into the wall via a microlter (not supplied).
If your main phone socket
has a single socket,
as shown, you’ll
need to use
microlters.
You don’t need to use
microlters if your main
phone socket has two
separate sockets, like
either of these:
Play
Skip
Skip
Volume
Delete
Find
Answer
On
Handset Base
Handset
1 The telephone line cord is already tted,
plug the other end into the wall socket.
2 Plug the mains power adaptor into
the base, with the cable clipped in the
groove provided.
3 Plug the other end of the power
adaptor into the wall power socket
and switch on.
Rechargeable batteries
already fitted
Remove this tab
and charge batteries
for 16 hours before use.
If you need to remove the batteries, place your ngers in the groove at the bottom
of the handset and lift the cover up to release it. Then gently ease the batteries out.
21 3
Charger
To Next Page
Need help?
General
