The display will flash for 38 seconds.
It will then show the normal ‘no
messages’ display. The display will flash
slowly until any button is pressed.
3 Plug the adaptor into
a mains power socket
BT Response 75 – Issue 2 – Edition 1 – 7/10/03
5
Setting up
Follow these steps to set up your BT Response 75 ready for use
Plan the location of your
BT Response 75
Situate your BT Response 75 close
enough to the phone and mains power
sockets so that the cables will reach.
To prevent the mains cable being
pulled out accidentally, place the cable
behind the clip on the back of the unit.
If you do not have a modern phone
socket, call Freephone 0800 800 150
and ask for a BT engineer to come and
fit the correct socket.
This is a chargeable service.
1 Check your telephone
wall socket
2 Plug the mains power
cord into the back of the
machine
To Next Page
Loading...
Need help?
General
