Engine Spacer
built from 1/2" plywood. Total
thickness is one inch. Carb must be installed
after engine is bolted to spacer.
F-1
shows carb cutout and four mounting holes
for spacer. Bottom hole is for ignition wire.
Carb Box
as recommended by Cactus Aviation.
Only bottom of carb box is attached to F-
top and sides are removable. Bottom of box has
large hole for air intake. Bellcrank is linked to
choke. Opening still needed for throttle linkage.
Landing Gear and Mount
have been drilled for six
10-
32 x 1" mounting bolts. Blind nuts in the mount
allow the gear to be removed easily for transport.
!
" # $ % &
"
" # $ % & '
'
# $ % & ( ) * % * +
, - -
$
# ./ 0
1
.- 0
('
+
To Next Page
Loading...
