! " !
# $
% &
%
'
& ( ( !) %
% &
* ( ( !% &
& % & " & %
& +&
, & %
( ( ! " !
- ( !.&
/ & .%
0 &
.% " & , . . ! 1
% %
& !
0+% & % &
2 &
& 3
. 0
% 4. !
, .
& &
% & &
& %
+& .+
& & & 51
" & , .
Fuselage Rear -
I know, the gussets and diagonals are missing in
this photo. The prototype wasn't built in exactly the same order
as the instructions. This photo does show the final result of the fin
f
ront "pocket". Notice the sheeting extends rearward slightly to
overlap the front of the stabilizer. Also notice that I added some
balsa triangle stock to reinforce the tailwheel mount.
Above -
Hatch removed. The hatch is held down
at the back using two 10-
into plywood blocks under the lite-ply. A lite-
tongue holds the hatch at the front. Below -
ply hardpoints are imbedded in top of hatch. The
fuselage corners have all been sanded round.