Center Wing Panel - Notice the screws holding
the bottom main spar to the table. The front
screw needs to be removed before the shear web
can be added. Note the grain of every shear web
must be vertical!
W-1 Wing Ribs -
I used a scrap stick to hold the
ends of the W-
1 ribs, but found out later it would
have been smarter to use
maybe one or two inches wide. Use only a few
spots of glue so it can be removed later. Also
notice in the photo the position of the aileron and
flap servo lead tubes. I moved the aileron tubes
forward in the production models to
for the large flap servos used in the prototype.
!" #
$ % &' (' )
"% &* +
,
-
# ( (. ('
/0
#
1 . (% . (2
,
1 . (* . (' . ('
3 4 5
6 % &% 7 #
. ('
1 . . (' !
, 8 9
,
1 # : ; < ; < 8 =
$ =
, 2 &2 '
. (%
: (
> ,
To Next Page
Loading...
