BTI 4.3 TFT - Page 4

In the e
vent your dash has a carbon fiber overlay, you will need spacer discs listed above
keep the proper distance and tension on the clock mount bracket
www.btigauges.com
These come
The wiring
is similar for all models. A
standard DTM connector cable with exception to customers whom selected the
Haltech 4 pin D
TM connector which is
AEMnet DTM connector standard.
connection opt
ions. Please see specific ECU integrations for wiring specifics.
4
vent your dash has a carbon fiber overlay, you will need spacer discs listed above
keep the proper distance and tension on the clock mount bracket
. These may be ordered at
These come
in a pa
ck of 3: 1mm, 2mm, and 3mm discs.
is similar for all models. A
ll integrations are shipped with the AEMnet
standard DTM connector cable with exception to customers whom selected the
TM connector which is
conveniently
wired 180 degrees from the
AEMnet DTM connector standard.
We then ship conversion pig-
tails for various ECU
ions. Please see specific ECU integrations for wiring specifics.
vent your dash has a carbon fiber overlay, you will need spacer discs listed above
(right) in order to
. These may be ordered at
:
ck of 3: 1mm, 2mm, and 3mm discs.
ll integrations are shipped with the AEMnet
standard DTM connector cable with exception to customers whom selected the
wired 180 degrees from the
tails for various ECU
ions. Please see specific ECU integrations for wiring specifics.