3
SAFETY GUIDELINES
GENERAL SAFETY GUIDELINES BEFORE USING THIS
POWER TOOL
• Always wear eye protection and respirator.
• Keep bystanders out of the work area while operating the tool.
• Wheel guards and eye shields must be properly adjusted and tightened.
• Always make sure wheels are properly mounted.
• Stand to the side of the sharpener during start-up. Switch it on and let the
sharpener operate at full speed for approximately one minute so that any
undetected
• Keep guards in place and working properly.
• Keep hands clear of grinding wheels.
• Never reach behind or beneath the grinding wheels.
• Disconnect power before changing grinding wheels or servicing. The grinding wheels
continue to rotate after the tool is switched off. Always allow wheels to stop before
adjusting or servicing. Do not stop the wheel with hands or workpiece.
• To avoid electric shock, DO NOT use in damp conditions or expose to rain.
meets or exceeds that stated on the sharpener. Also check the new wheel for damage,
and switch it on. Let the sharpener operate at full speed for approximately one
minuteso that any
• Use only accessories that are recommended by the manufacturer for your model.
• DO NOT attempt to cut anything with the grinding wheel.
• Grounded tools must be plugged into an outlet that has been properly installed
and grounded in accordance with all local codes and ordinances. Never remove the
Do not use adaptor plugs. If in doubt as to whether the outlet is properly grounded,
• Do not wear loose clothing, gloves or jewellery; tie up long hair and button all
long sleeve shirts.
• Ensure the power switch is off prior to plugging in the tool.
• Do not overtighten spindle nuts.
• Spacing between tool rests and wheels should be set to 1/8” or less; hold
workpiece
•
grounding prong from the plug or modify it in any way.
•
Failure to follow these rules may result in serious personal injury.
SCM8080
• Do not use the tool when tired or under the influence of drugs, alcohol or medication.
• Service on these tools should only be performed by an authorized, qualified
technician.
WARNING!
!
To Next Page
Loading...
