Buderus Logamatic 4323 - Substation Monitor Data

Monitor data
21
Logamatic 4323 - Subject to technical modifications.
112
21.3 Substation monitor data
Call up the service level. "Gen. parameters" is shown as the first main menu.
Turn the rotary selector until the main menu "Monitor" appears.
Press "Display" to call up a submenu (here: "Heating circ. 0").
The display shows the selected submenu.
Turn the rotary selector until the required submenu appears (here: "Substation").
The display shows the selected submenu.
Press "Display".
The "Outside" value indicates the current outside temperature.
The "Adjusted" value describes the outside temperature, taking the specified
type of building into consideration, with which the heating curve was calculated.
The "Flow" value indicates the flow temperature (set value/actual value) that
is captured by the master via the feed sensor, and that is transmitted by a
substation via the ECOCAN-BUS.
Turn the rotary selector to scroll through the substation monitor data.
System flow (set value/actual value)
The system flow of the control unit network is indicated.
The value "ext. demand" indicates a further heat demand in °C via terminal U
(connection 1 and 2) in accordance with the diagram on
Page 16.
The "Pump" value indicates the status of the feed pump.
Press "Back" to return to the next level up.
+
+
MONITOR
Heating circ. 0
MONITOR
Substation
Substation
Flow 60/59
Adjusted 4
Outside 5
Substation
Pump off
Ext. demand 0
System FL
60/59