Buderus Logamatic 4323 - Page 49

Heating circuit data
11
Logamatic 4323 - Subject to technical modifications.
49
Call up the service level. "Gen. parameters" is shown as the first main menu.
Turn the rotary selector until the main menu "Heating circ. + no." appears
(here:
"Heating circ. 2").
Press "Display" to call up a submenu (here: "Heating system").
The display shows the selected submenu.
Turn the rotary selector until submenu "Remote control" appears.
The display shows the selected submenu.
Hold down "Display" and select the required value with the rotary selector (here:
"with display"). Turn the rotary selector to "with display" if the selected heating
circuit has been assigned to the MEC2.
The display shows the set value.
Release "Display" to save your input.
Press "Back" to return to the next level up.
+
+
HEAT CIRC. DATA 2
Radiators
Heating system
HEAT CIRC. DATA 2
none
Remote control
+
HEAT CIRC. DATA 2
with display
Remote control
Input range Factory setting
Remote control
none
without display
with display
none