Buderus Logamatic 4323 - Changing the Permanent Display

Extended functions
7
Logamatic 4323 - Subject to technical modifications.
29
Subject to the modules, various of the following operating displays can be
called
up:
– Burner and hours run
– Actual heating circuit room temperature
– Set heating circuit room temperature
– Heating circuit operating state
– Actual heating circuit flow temperature
– Actual DHW temperature*
– Set DHW temperature*
– DHW operating mode*
– DHW circulation pump and cylinder primary pump operating state*
* Only if a DHW module has been installed.
7.4 Changing the permanent display
You can determine the permanent display of the programming unit.
The following permanent displays are available:
– Common flow (if MEC2 is installed in the wall bracket)
– Outside temp.
– Domestic hot water*
– Time
– Date
* Only if a DHW module has been installed.
Hold the "Display" key down, and select the required permanent display with
the
rotary selector (here: "Date").
Release the "Display" key. The selected permanent display has now been
saved.
Heating circ. 0
20°C
Set room
AUT
+
Common flow
Date
20.08.2001
45°C