Buderus Logamatic 4323 - Adjusting the Room Temperature for Another Heating Circuit

Extended functions
7
Logamatic 4323 - Subject to technical modifications.
32
7.7 Adjusting the room temperature for another heating circuit
Your heating system may be equipped with several heating circuits. If you want
to change the room temperature for a different heating circuit than the one last
selected, first select the required heating circuit.
Subject to the equipment level of your heating system, the following heating
circuits can be selected:
– MEC2 heating circuits (all heating circuits assigned to the MEC2,
Æ
Chapter 7.8)
– Heating circuit 0 – 8
If several heating circuits are assigned to the MEC2, the temperature for these
heating circuits can only be adjusted for all. Otherwise a fault message "Setting
Not possible. MEC heat. circ. select" will appear. In such cases select
"MEC
heat. circ.".
z Open flap.
Hold down the "Heating circuit" key, and select the required heating circuit with
the rotary selector (here: "Heating circ. 2").
Release the "Heating circuit" key. The displayed heating circuit is now selected.
As soon as heating circuit has been selected, the display returns to the
permanent display.
AUT
AUT
+
Heat. circ. sel.
Heating circ. 2
Actual room
Outside temp.
0°C
19.5°C