Buffalo CF764 - Page 9

8
Changing User Options
User options can be changed to suit individual preferences
1. Open the door
• Display turns off
2. Press and hold number 2 pad
• Oven enters Options mode and will show OP:-- in the display
3. Press number pad to be programmed (0-9)
• Program number will show in the display
4. Press the number pad again to change the option.
• Each time the number pad is pressed the option will change
5. Press START pad to save changes
• To change additional options, repeat steps 3 and 4
Pads Display User Options (Factory Settings in Bold)
1
Cook Ending Signal
OP:10
OP:11
OP:12
OP:13
OP:14
3 long beeps for 3 seconds
1 short, 1 long beeps for 3 seconds
3 seond beep
3 quick beeps for 3 seconds
5 quick beeps for 3 seconds
2
Repeat Feature
OP:20
OP:21
Repeat feature not allowed
Repeat feature allowed
3
Key Beep On/Off
OP:30
OP:31
Prevents beep when a pad is pressed
Allows beep when pad is pressed
4
Keypad Activating Time
OP:40
OP:41
OP:42
OP:43
Keypad time entry window is 1 minute
Keypad time entry window is 2 minutes
Keypad time entry window is 3 minutes
Keypad time entry window is 4 minutes
5
On-the-fly Feature
OP:50
OP:51
On the fly disabled
On the fly enabled
6
Reset on Door Opening
OP:60
OP:61
Opening oven door does not reset oven back to ready
Opeing the oven door resets the oven back to ready mode
7
Maximun Cooking Time
OP:70
OP:71
Allows 60 minute maximum cooking time
Allows 10 minute maximum cooking time
8
Manual Programming
OP:80
OP:81
Manual cooking not allowed
Manual cooking allowed
9
Multiple Digit Entry
OP:90
OP:91
Single digit entry allows 10 preprogrammed pads (0-9)
Multiple digit entry allows 200 preprogrammed pads (0-199)
0
Clean Filter Message
(Note:Message is
reminder only and will
clear after 24 hours.)
OP:00
OP:01
OP:02
OP:03
Oven will not display Clean Filter message
Oven will display Clean Filter message every 7 days
Oven will display Clean Filter message every 30 days
Oven will display Clean Filter message every 90 days