HOW TO ASSEMBLE
2 PLAYERS
AGE / AGE
10+
STEP 1.
Place the Base on the table face-up
so you can see the letter A.
Insert the Pillar into the Base until it
clicks into place (or until snug) -
with the A side down as shown.
STEP 2.
Place the Inner Ramp onto the top
of the Pillar by inserting the top of
Pillar into the corresponding shape
on the bottom of the inner ramp.
Push until snug.
STEP 3.
Place the Cone into the base of
the Inner Ramp by pushing it
onto the pegs until snug.
Find the 6 individual D panels D1-D6 and attach them
around the inner ramp. Each panel is numbered and
matches the number of a side on the inner ramp.
Attach a panel by inserting the 2 bottom squares over
2 pegs on a side of the inner ramp.
(*Helpful tip: hold the inner Cone steady with one hand
while putting the D1-D6 parts on the inner Ramp.)
You're almost finished!
Pop each of the 6 E ramps into place on each side of the
inner Ramp. To do so, insert each of the ramp’s
2 pins into the pin slots on the outside of each panel.
(*Helpful tip: When inserting give the Ramp a slight
squeeze on the sides to get the pins into the slots.
You should get a little pop when it is in the correct place.)
STEP 6.
A
Pillar
Base
Inner Ramp
Parts D1-D6
Slide each of the 6 Clips marked as F onto the panels
of the tower cup to join the two panels together.
When all 6 Clips are used the tower cup is assmebled.
Now you’re ready to play!
STEP 4.
STEP 5.
ASSEMBLY PARTS
F Clip (6)
E Ramp (6)
ConeInner Ramp
Pillar
Base
D Panel (6)
F Clip
E Ramp
Questions or
Comments?
855-895-4290
M-F 9-5 EST
Cone
To Next Page
Need help?
General