Enable/disable the password function
Enter default passcode "0000" to start device. Long-press the ambient light icon and cruising
function icon at the same time, it will enable/disable the password function.
(Password is stored in memory setting)
Password input
Use the headlight icon , ambient light icon, speed mode icon, and cruising functions icon to input
passcode. Choose digits range 0-9 from le to right.
1st digit: Touch “Headlight” button.
2nd digit: Touch “Ambient light” button.
3rd digit: Touch “ Speed mode” button.
4th digit: Touch “Cruise control” button.
Aer the 4-digit password has been set, single-press the power button to enter into standard
screen mode.
Reset password
-Press the "headlight" button and "speed mode" button for more than 5-seconds at the same time
to reset the password.
-Input the old password "0000" before reseting password. Single-press power button to conrm
the old password input. Screen will show “0000” and now you can input a new password.
-Enter the new password and single-press power button to conrm the new password.
Restore initial password
While holding the brake lever, long press the ambient light button and cruising function button
for more than 5 seconds, you can restore the initial password "0000".
Cancel/bypass password function
When screen is on, long-press both “Ambient light” and “Cruise control” buttons for more than
5-seconds. Even if the screen shows “0000”, continue to press the two buttons for few seconds.
e screen will return back to standard mode automatically. is conrms the password function
has been canceled or bypassed.
To Next Page
Loading...
