#360 Grain Cleaner
- 3 -
MODEL #360 GRAIN CLEANER ASSEMBLY INSTRUCTIONS
ALERT: The following instructions refer to the intake end of the cleaner as the
front and the output end as the rear.
1. Join the front frame (#1) and rear frame (#2) with two frame sides (#3) using four
frame clamp plates (#6) with 5/16" x ¾” cap screws, lock washers and hex nuts.
Bolt the frame cross brace (#4) between the frame sides using two frame clamps
(#5). The hitch (#7) is pushed through the holes in the rear frame and frame
cross brace and fastened to the frame cross brace with a 3/8" x 4" cap screw and
lock nut. The hitch length is adjusted by moving the position of the frame cross
brace.
CAUTION: All bolts connecting the fame must be firmly tightened. Any loose
bolts could result in the frame separating while towing the cleaner.
2. Slide the front legs (#11) into the sleeves at the bottom of the front frame.
A 3/8" x 2" cap screw, lock washer and hex nut through each leg is used to
adjust the height of the front of the cleaner. Place a wheel spacer (#12) on the
stub shafts and mount the wheels (#13). The wheels are held on by a 1" I.D. flat
washer and a ¼” x 1 ½” cotter pin. A 5/16" x ¾” cap screw, lock washer and hex
nut is bolted through one of the holes at the top of the leg to keep it from sliding
out.
3. Mount two 1" pillow bearings (#16) on the reducer shaft (#18) and bolt the
bearings to the bottom of the reducer mount welded to the front frame as shown
in drawing. Use ½” x 1 ¾” cap screws, lock washers and hex nuts. Bolt the idler
arm (#25) to the same reducer mount using a 5/8" x 1 ¾” cap screw and lock nut.
The end of the idler arm with the small hole is turned to the outside of the frame.
Mount the idler pulley (#24) to the other end of the idler arm. A 5/8" I.D. flat
washer is placed between the idler pulley and the idler before tightening with a
5/8" jam nut. A 3" pulley (#19) is mounted on the inside of the reducer shaft and
a 15" pulley (#26) is mounted on the outside.
4. Bolt the motor mount (#33) to the front frame with two motor mount clamps (#34)
using 3/8" x 1" cap screws, lock washers and hex nuts. The tightener hole in the
side of the motor mount must face the tightener bracket welded to the front
frame. Connect the belt tightener rod (#35) between the motor mount and the
welded bracket on the frame using two 3/8" hex nuts. Bolt the motor guard (#32)
and 1 H.P. electric motor (not supplied) to the motor mount using 5/16" x 1" cap
screws, lock washers, flat washers and hex nuts. Mount a 2 ½” pulley (#29) on
the electric motor and connect this pulley and the 15" pulley (#26) with a B-62
V-belt (#28). Tighten belt using belt tightener rod (#35).
To Next Page
Loading...